Keywords
fundamental wave active current, cophase power supply, Scott balance transformer, balancing gear
Abstract
When itoccurs load mutation in cophase power supply system, conventional detection method in detecting the fundamental active current and reactive current will exist a time buffer, which in turn directly affects the detection effect of fundamental active current and reactive current at power grid side. It may lead to not timely compensate the reactiveand harmonic current in load side. Based on the above problems, this paper proposed a Scott balance transformer combined balance transform device of cophase traction power supply system mode. The twophase voltage and current analysis Through the special power supply mode of the twophase balance transformer. According to the instantaneous reactive power theory of twophase circuit, the whole singlephase fundamental wave active and reactive current signals aredetected.Theactive current in the whole singlephase circuit is decomposed. Thus,the amount of negative sequence can be obtainedin the case of mutation, and then the positive sequence under the condition of fundamental wave stability is recombined with the negative sequence. Therefore, the dynamic performancegets greatly improved when it occurs load mutation. Simulation and theoretical comprehensive analysis verify the rationality of this method.
DOI
10.19781/j.issn.16739140.2020.04.020
First Page
147
Last Page
153
Recommended Citation
WEI, Rui; ZHOU, Lixing; PENG, Chaomin; CHEN, Hao; SHI, Lingwei; and ZHOU, Luping
(2020)
"In phase change in load current monitoring method in power system research,"
Journal of Electric Power Science and Technology: Vol. 35:
Iss.
4, Article 20.
DOI: 10.19781/j.issn.16739140.2020.04.020
Available at:
https://jepst.researchcommons.org/journal/vol35/iss4/20